Get help for free

Buy spores

✖

Guide

Cultivation

TEKs

MonoTub gallery on Shroomok | Page #2

Shroomok's choice

Pasteurized CVG Substrate

Millet Grain, 3 lb

DIYhz Aluminum Water Cooling Block, Liqu...

Quiet Oxygen Pump for 20-100 Gallon - 2...

Vertical Laminar Flow Hood, Clean Bench...

4-Piece Hobby Tweezers Set

Amazon Stainless Steel Digital Kitchen S...

Wide Mouth Jars with Airtight Lids and L...

Digital Hygrometer, Thermometer

Hot Mini Glue Gun with Case and 20 Stick...

Inkbird Digital Temperature Controller

Spice Herb Coffee Grinder with Pollen Ca...

2

This first time trying was a LOT of failures and now I'm worried about anything that even looks a little funny - oyster mushrooms in monotub #3

This first time trying was a LOT of failures and now I'm worried about anything that even looks a little funny - oyster mushrooms in monotub #2

This first time trying was a LOT of failures and now I'm worried about anything that even looks a little funny - oyster mushrooms in monotub

For FAE I just leave the lid to the tub offset. The only other holes I have are these small ones all along the sides. Covered in micropore tape

Growing mushrooms in DubTubs

Automated mushroom growing setup

Transfered jars to monotub and took 6 samples from best performing jar and place into agar #3

Transfered jars to monotub and took 6 samples from best performing jar and place into agar #2

Monotub in my fridge tek - details in description

Got my monotub build done. Details in description

Monotub in old fridge. Fridge tek moves to the tub #2

My 3d printed polyfill filter holders got installed into my monotub #2

My 3d printed polyfill filter holders got installed into my monotub

Split the tub into 1/3rds to make air vents properly

3D printed for monotub air filter #2

3D printed air filter

Printed the other half of my filter. Fill with Poly fill and screw the 2 sides together through the side of my tub and it should end up with a nice clean look

Because my OCD won't just let me stuff polyfill in a hole and tape it in, I used 3D printer and printed part 1 of my filters

Psilocybe natalensis mushroom growing

Trial. I haven't put my tub in yet and I have yet to play with humidity. But I feel like temp control will not be an issue

Load more photos

Take a look at the following publications